Component Location Overview - Drain Plug, Fill Plug And Check Plug

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All assembly work and tightening specifications are also outlined in the "S tronic Transmission Internal Components" service information.

Fig 1: ATF Drain, Fill And Check Plugs Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

ATF Drain Plug
- Tightening specification 45 Nm
Seal
- For the ATF drain plug
- Replace
Transmission Fluid, Manual Transmission Fluid (MTF) Fill and Check Plug
- Tightening specification 45 Nm
- Inside the manual transmission, front final drive and transfer case
ATF Fill and Check Plug
- Tightening specification 45 Nm
Transmission Fluid (MTF) Drain Plug
- Tightening specification 45 Nm
- Depending on the date of manufacture, Transmission Fluid Temperature Sensor 2 -G754- may also serve as the transmission fluid drain plug; tightening specification for removing and installing. Refer to TRANSMISSION FLUID, DRAINING AND FILLING for Vehicles with Transmission Fluid Temperature Sensor 2 -G754- -1- Instead of a Transmission fluid (MTF) Drain Plug.