ATF Lines, Removing And Installing: Installing: Clean

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Guidelines for clean working conditions when working on the dual clutch transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Always clean the oil lines and oil cooler before installing a new transmission.

WARNING: Danger of eye injury.

Wear protective eyewear.

Courtesy of AUDI OF AMERICA, LLC

Place the Used Oil Collection and Extraction Unit - SMN372500- under the separating points.
Remove the bolts -arrows- and remove the ATF hose lines.
Clean the ATF cooler and the ATF line/hose lines use compressed air (maximum 10 bar (145.04 psi)).
Install in reverse order of removal. Refer to ATF LINES, REMOVING AND INSTALLING

NOTE: If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and the ATF line/hose line using clean ATF.