Clutch Release Mechanism, Servicing: Installing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the guide sleeve -6- and install together with the locking plate -5-.
NOTE:
The securing plate -5- is omitted when a new guide sleeve -6- is installed.
-- Clean the screw threads -4- with a wire brush. Insert the bolts with Locking Fluid AMV 185 101 A1 and tighten. Tightening specification. Refer to -item 6- Bolt (See Figure).
CAUTION:
>>Rattling noises<< when using the clutch.
- Apply Grease G 000 150 to the clutch release lever bearing areas, Refer to -item 5- Clutch Release Lever (See Figure).
-- Engage the release bearing -2- and the spring -3- into the clutch release lever -1- and install them both.