Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

INSTALL FRONT SEATBACK HEATER (SEPARATE TYPE FRONT SEATBACK COVER)
1. Using hog ring pliers, install the front seatback heater (separate type front seatback cover) to the separate type front seatback pad with 14 new hog rings.
  
  Fig 1: Installing Hog Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Be careful not to damage the front seatback heater (separate type front seatback cover).
  - Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the front seatback heater (separate type front seatback cover).
INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD See step 23
CONNECT CONNECTOR See step 7
INSTALL SEATBACK CLIMATE CONTROL COVER (w/ Climate Control Seat System) See step 24
INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY See step 25
INSTALL FRONT SEAT CUSHION SHIELD See step 30
INSTALL FRONT POWER ADJUSTER SHIELD See step 37
INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD See step 38
INSTALL FRONT SEAT INNER CUSHION SHIELD See step 42
CONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY (w/o Foot Light) See step 44
CONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY (w/ Foot Light) See step 45
INSTALL POWER SEAT SWITCH ASSEMBLY (for Front Passenger Side with Power Seat Switch Assembly) See step 1
INSTALL FRONT SEAT ASSEMBLY
Refer to INSTALLATION [08/2013 - ]