LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Air Conditioning System (Service Information)) >> Air Conditioning Pressure Sensor >> Installation [08/2013 - ] >> Installation [08/2013 - ]

Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL AIR CONDITIONER PRESSURE SENSOR 
    1. Remove the vinyl tape from the air conditioning tube and accessory assembly and the connecting part of the air conditioner pressure sensor.
    2. Apply sufficient compressor oil to a new air conditioner pressure sensor and the connecting surface.

      Compressor oil

      ND-OIL 11 or equivalent

    3. Using a 27 mm deep socket wrench, install the air conditioner pressure sensor.
      Fig 1: Installing Air Conditioner Pressure Sensor
      GTY407784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Connect the connector.
  2. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT  See step  2
  3. WARM UP COMPRESSOR  See step  3
  4. INSPECT FOR REFRIGERANT LEAK  See step  4
scientia non olet · About LEMON Manuals