Mirror adjuster switch, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove front door trim:

Refer to 70 - INTERIOR TRIM

Fig 1: Identifying Bolts At Pull Handle For Closing On Back Side Of Door Trim

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -arrows- at pull handle for closing on back side of door trim.
Remove panel for pull handle for closing on front side, under mirror adjuster switch.

Fig 2: Identifying Connector At Mirror Adjuster Switch, And Catches

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connector -1- at mirror adjuster switch -2-.
Carefully release catches -arrows- using a small screwdriver.
Pull mirror adjuster switch downward out from pull handle for closing.

Installing

Installation is reverse of removal, paying attention to the following:

Press mirror adjuster switch into switch mount until catches engage.