Light bulb for low beam, replacing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove headlight. Refer to Headlights, removing and installing: .
Remove housing cover from headlight housing.

Fig 1: Identifying Harness Connector At Low Beam Bulb, Wire Clamp, And Bulb

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect harness connector -1- at low beam bulb.
Disengage wire clamp -2- and remove bulb -3- from housing.

Installing

Installation is reverse of removal, paying attention to the following:

Insert new bulb into housing, do not touch glass portion with bare hands.
Secure bulb using wire clamp.
Reconnect harness connector and close housing cover.
Secure housing cover using wire clamp.