Dual-mass flywheel pilot needle bearing, removing and installing: Notes

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and equipment

Fig 1: 3264 Bearing Driver

Courtesy of VOLKSWAGEN UNITED STATES, INC.

3264 Bearing driver

Fig 2: Kukko 21/2 Internal puller, Kukko 21/4 Internal puller, Kukko 22/2 Counter support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tool Kukko 21/1 (Item -1-) and Kukko 22/1 (Item -4-)

Procedure

Transmission removed

Remove clutch pressure plate.

Refer to

30 CLUTCH for 5 SPD. MANUAL TRANSMISSION 012/01W FRONT WHEEL DRIVE
30 CLUTCH for 5 SPD. MANUAL TRANSMISSION 01A ALL WHEEL DRIVE
30 CLUTCH for 6 SPD. MANUAL TRANSMISSION 01E ALL WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 01X, FRONT-WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 02X, FOUR-WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 0A3, ALL WHEEL DRIVE

Fig 3: Pulling Out Needle Bearing Using Kukko 21/1 And Kukko 22/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull out needle bearing using Kukko 21/1 and Kukko 22/1.

Fig 4: Driving Needle Bearing Into Flywheel Using 3264 Bearing Driver

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive needle bearing into flywheel using 3264 bearing driver.

Installation depth. Refer to Needle bearing installation depth