Defroster outlet vent intermediate piece for front windshield, removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove instrument panel →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
- Remove mounting bracket for brake pedal (and clutch pedal) from instrument panel cross member. Refer to → 46 - BRAKES - MECHANICAL COMPONENTS
- Loosen hex nuts - A
- for instrument panel cross member on left and screw out by approx. 15 mm. →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
- Remove hex nuts - B
- for instrument panel cross member on right →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
- Remove connecting bolts between instrument panel cross member and windshield cross member (in passenger compartment) as well as connecting bolts between instrument panel cross member and plenum chamber (between electronics box and windshield cross member in plenum chamber). →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
- Carefully pull instrument panel cross member to rear until it makes contact with nuts on left and is still resting on stud on right.
- Remove intermediate piece - A - from instrument panel cross member - B -.
- Remove intermediate piece - A -.