Fuel Tank Lid Unlock Motor V155, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Tank Lid Unlock Motor V155 Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Motor for fuel tank lid unlock V155
Locking pin
Fuel filler flap

Fig 2: Locating Bolts And Socket Wrench T10010, Sliding Actuator Up And Removing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Disconnect electrical connector.
Loosen bolts - arrows - using Socket Wrench T10010 , slide actuator - 1 - up and remove.

Fig 3: Fuel Filler Flap Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Before installing actuator, emergency release - 2 - must be slid over the locking pin.
Locking pin of actuator must move cleanly into closed fuel filler flap - 2 -.
Clip in grommets - 1 -.

NOTE:

To remove fuel filler flap, remove bolts - 5 -.
Panel gap dimensions Panel gap dimensions .

Tightening torques → Component locations .