LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Suspension, Wheels, Steering) >> 48 - Steering >> Power steering pump delivery pressure, checking >> Vehicles with 4-cylinder engine

Vehicles with 4-cylinder engine

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Tools - Power Steering Pump Delivery Pressure
GW00006704Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required 

Fig 2: Identifying Hose Clamps 3094
GW00006691Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • If adapter V.A.G 1402/3 threads are too long, use more seals.
NOTE:
  • To avoid damage to pump, observe the following:
  • Pressure gauge shut-off valve must not remained closed longer than 10 seconds during this test.
  • Start engine without giving gas and run at idle.
  • Read pump pressure immediately after starting at idle speed (have it read by second technician, if necessary).
  • Because pressure falls over the course of the test, the highest pressure shown is the decisive measurement.

Pump pressure specified value (positive pressure) 

Engine Pump Pump pressure (bar
4-cylinder gasoline engines 8E0 145 153 B 8E0 145 153 8E0 145 155 L 110 to 118 110 to 118 110 to 118

If pressure is not to specification, replace pump → Power steering pump, removing and installing .