Inner CV joint, removing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Drive axle, clamping in vise

Use protective vise covers for this.

Fig 1: Driving Cover Down With Copper Or Brass Drift

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive cover down with copper or brass drift

Fig 2: Removing/Installing Circlip

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove circlip
Remove joint grease and mark location of CV joint to drive axle.

Fig 3: Clamping Drive Axle In Vise At CV Joint

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Clamp drive axle in vise at CV joint, as shown in illustration.
A 2nd technician must hold drive axle horizontally so that CV joint is not damaged.
Bend edge - arrow - of cap up slightly with small flat chisel.
Drive cap down with copper or brass drift

Fig 4: Pressing CV Joint Off Of Drive Axle

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press CV joint off of drive axle.
Remove protective boot with cap.