Inner CV joint, removing

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Drive axle, clamping in vise

Use protective vise covers for this.

Fig 1: Prying Off Cap With Screwdriver

GW00019866

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pry off cap, e.g. with a screwdriver.

Fig 2: Identifying Seal

GW00019867

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove seal - arrow -

Fig 3: Driving Protective Joint Boot Cap Under With Brass

GW00019868

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive protective joint boot cap under with a brass or copper drift

Clamping sleeves must not be loosened.

Fig 4: Removing/Installing Circlip

GW00019869

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove circlip

Fig 5: Pressing Inner CV Joint Off Of Drive Axle With Special Tool

GW00019870

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press inner CV joint off of drive axle with special tool shown in illustration.
Remove inner CV joint protective boot from drive axle.