Tailpipes, aligning

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking Distance Of End Pipes At Left/Right To Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Check distance of end pipes at left and right to bumper:

Dimension - x - left = dimension - x - right.

If necessary, correct dimension x as follows:

Fig 2: Locating Nut Of Brace Between Exhaust Pipes

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen nut - arrow - of brace between exhaust pipes.
Adjust distance between rear mufflers.
Tighten nut to 23 Nm.

Fig 3: Checking Distances Of End Pipes To Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Check distances - y - and - z - of end pipes to bumper:

Dimension - y - = greater than 20 mm.
Dimension - z - = 10 to 16 mm.

If necessary, check whether exhaust system is aligned tension-free → Exhaust system, installing tension free .