Transmission cover, dismantling and assembling: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Thrust plate VW 401
- Thrust plate VW 402
- Press tool VW 408 A
- Press tool VW 412
- Press tool VW 454
- Press tool VW 554
Special tools, testers and auxiliary items required
- Punch 2005
- Thrust piece 2050
- Drift sleeve 30 - 100
- Shim 016 311 391 A
1 - Flange shaft
- Pressing out Pressing out flange shaft (transmission cover with vibration damper) or Pressing out flange shaft (transmission cover without vibration damper)
- Pressing in Pressing in flange shaft
2 - Bolt, 20 Nm + 90°
- For vibration damper
- 3 x
- Self-locking
- Replace
3 - Vibration damper
- Not installed on all versions
4 - Oil seal
- Levering out Levering off the oil seal.
- Preparing for installation Preparing oil seal for installation
- Driving in Drive in seal onto stop.
5 - Transmission cover
- Removing and installing → Transmission cover and Torsen differential, removing and installing
6 - Ball bearing
- For flange shaft
- Pressing out Pressing out ball bearing for flange shaft
- Pressing in Pressing in ball bearing for flange shaft
7 - Circlip