LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (6-Speed Manual Transmission 0A3, All Wheel Drive) >> 34 Controls, housing >> Selector shaft with selector cylinder, servicing >> Selector shaft with selector cylinder, removing and installing

Selector shaft with selector cylinder, removing and installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required 

Fig 1: Slide Hammer-Multi-Purpose Tool Set VW 771
GW00001531Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 2: Puller T40050
GW00019186Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 3: Removing Bolts And Selector Shaft Cover
GW00019187Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

Fig 4: Pulling Out Both Selector Shaft Locking Bushes Using Multi-Purpose Tool VW 771/1 And Puller T40050
GW00019188Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 5: Pushing Selector Shaft Into Transmission & Removing Pin
GW00019189Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Fig 6: Installing Seal And Selector Shaft With Assembly Sleeve
GW00005732Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installation is performed in reverse sequence; note the following:

Fig 7: Pushing Selector Shaft Into Transmission & Removing Pin
GW00019189Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 8: Removing Bolts And Selector Shaft Cover
GW00019187Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 9: Driving In Selector Shaft Locking Bushes Onto Stop
GW00019190Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tightening torque 

Component Nm
Selector shaft cover to transmission 24