Transmission mounting, removing and installing

Special tools, testers and auxiliary items required 

Fig 1: Identifying Engine/Transmission Jack V.A.G. 1383 A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Engine/transmission jack V.A.G 1383 A

Fig 2: Front And Rear Sound Insulation And Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• If installed, loosen quick-release fasteners - 3  - and remove rear sound insulation - B  -.

Fig 3: Exhaust System And Clamps

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect exhaust system at clamps - arrows  -.

Fig 4: Transmission Raised Using Punch Of VAG 1383 A So That A Piece Of Wood Can Be Placed In Between

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Use engine/transmission jack V.A.G 1383 A to lift transmission up slightly. Insert a wooden block - 1  - between transmission and transmission jack.

Fig 5: Tunnel Cross Member Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - 3  - and then bolts - 2  - at tunnel cross member.
• Lower transmission slightly.
• Remove two nuts - 1  - and push tunnel cross member backward slightly.

Fig 6: Transmission Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove transmission mounting - arrows  -.

Fig 7: Transmission Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Installation is in reverse sequence. Note the following:

• Secure transmission mounting to transmission - arrows  - (tightening torque: 23 Nm).

Fig 8: Tunnel Cross Member Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Bolt tunnel cross member onto transmission mounting - arrows  -.

Fig 9: Tunnel Cross Member Mounting Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Lift transmission far enough to be able to screw in bolts - 2  -.
• Tighten bolts - 2  - and then bolts - 1  - → 40 - FRONT SUSPENSION .

• Install exhaust system so it is free of stress →
  • 26 EXHAUST SYSTEM, EMISSION CONTROLS for AVK
  • 26 - EXHAUST SYSTEM, EMISSION CONTROLS for BPG
  .

Tightening torques