Enable Conditions: Notes
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
ENABLE CONDITION REFERENCE CHART
| Secondary Parameters | Enable Conditions |
|---|---|
| Battery voltage | > 10.9V |
| Atmospheric pressure | > 75 kPa (563 mmHg, 22.2 inHg) |
| A/F main learning system | In operation |
| Engine speed | > 450 RPM |
| Engine coolant temperature | > 70°C(158°F) |
| Intake air temperature | < 70°C (158°F) |
| Engine load | > Value of Map 1 |
| Engine load change | < 0.02 g/rev (0 oz/rev) |
| Evaporative system leak check | Not in operation |
| Cumulative time of canister purge after engine start | ≥ 20s |
| Learning value of EVAP cone. | < 0.2 |
| Vehicle dynamic control or AT torque control | Not in operation |
| Intake manifold pressure change at 180°CA | < Value of Map 2 |
| Throttle position change during 16 milliseconds | < 14° |
| Fuel shut-off function | Not in operation |