Enable Condition: Notes
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
ENABLE CONDITION REFERENCE CHART
| Secondary Parameters | Enable Conditions |
|---|---|
| All secondary parameters enable conditions | ≥ 1024 ms |
| Intake manifold pressure change at 180°CA | < Value of Map 1 |
| Throttle position change during 16 milliseconds | < 14° |
| Fuel shut-off function | Not in operation |
| Fuel level | ≥ 9.6 l (2.54 US gal, 2.11 lmp gal) |
| Vehicle dynamic control or AT torque control | Not in operation |
| Evaporative system leak check | Not in operation |
| Engine speed | 450 RPM - 6650 RPM |
| Intake manifold pressure | ≥ Value of Map 2 |
| Battery voltage | ≥ 8V |
| Fuel parameter determination | Not extremely low volatility |
| Elapsed time after starting the engine | ≥ 0 ms |
| Engine load change during 32 milliseconds | < 1000 RPM |