LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Occupant Detection System (Diagnostics)) >> Airbag Connector >> Procedure >> Occupant Detection System (Between Airbag Rear Harness And Seat Harness & Belt Tension Sensor)

Occupant Detection System (Between Airbag Rear Harness And Seat Harness & Belt Tension Sensor)

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. How to disconnect:

    Press the lock arm (A) to disconnect the connector.

    CAUTION: When pulling the slide lock or disconnecting the connector, make sure to hold the connector rather than the harness.
    Fig 1: Identifying Airbag Connector Lock Arm
    G07681255Courtesy of SUBARU OF AMERICA, INC.
  2. How to connect:

    Hold the connector and push in firmly until it clicks.

    CAUTION: Make sure to insert the connector until the connector is locked. Pull lightly to confirm that it is fixed securely.
scientia non olet · About LEMON Manuals