Display of Status Information: Operation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.

On << Main Menu >> display, select {Each System Check}.
On << System Selection Menu >> display, select {Airbag System}.
On << Airbag System >> display, select {Status Data}.

The following table is for support data.

SUPPORT DATA

Item

Display

Seat position sensor LH

-⁽²⁾

Seat position sensor RH

-⁽²⁾

Seat belt buckle switch LH

-⁽⁶⁾

Seat belt buckle switch RH

Equipped⁽³⁾

Passenger's airbag control status

ON⁽⁷⁾

⁽¹⁾	Displayed when it is initial.

⁽²⁾	Seat position sensor not supported

⁽³⁾	Seat belt fastened

⁽⁴⁾	Seat belt not fastened

⁽⁵⁾	Displayed when data other than belt fastened or not fastened, such as breakdowns is input.

⁽⁶⁾	Seat belt buckle switch not supported

⁽⁷⁾	Passenger's airbag operating state

⁽⁸⁾	Passenger's airbag non-operating state

NOTE: For detailed operation procedures, refer to PC application help for Subaru Select Monitor.