LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Anti-Theft System - Immobilizer (Diagnostics)) >> Subaru Select Monitor >> Operation >> How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit.
  2. Connect the diagnosis cable to Subaru Select Monitor.
  3. Connect the Subaru Select Monitor to data link connector.
    1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
      Fig 1: Locating Data Link Connector Is Located In Lower Portion Of Instrument Panel (On Driver's Side)
      G07681426Courtesy of SUBARU OF AMERICA, INC.
    2. Connect the diagnosis cable to data link connector.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  4. Turn the ignition switch to ON and start the Subaru Select Monitor.
  5. Using the Subaru Select Monitor, call up DTCs and various data, then record them.
scientia non olet · About LEMON Manuals