LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)) >> PCV Valve >> Installation

PCV Valve: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCV valve to the PCV connector and connect the vacuum hose (A) to the PCV valve.
    NOTE: Use a new clamp for the PCV connector clamp, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

    ST 18353AA000 CLAMP PLIERS

    Fig 1: Fittng Cut Out In ST With Protrusion On Clamp
    G07679893Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Locating Vacuum Hose Clamp
    G07679894Courtesy of SUBARU OF AMERICA, INC.
  2. Install the secondary air combination valve RH. < refer to INSTALLATION , Secondary Air Combination Valve. >
  3. Install the intake manifold. < refer to INSTALLATION , Intake Manifold. >
  4. Install the collector cover.
scientia non olet · About LEMON Manuals