Oil Pressure Switch: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Apply liquid gasket to the oil pressure switch threads.
Liquid gasket:

THREE BOND 1324 (Part No. 004403042) or equivalent

Fig 1: Identifying Oil Pressure Switch Threads Liquid Gasket Applying Points
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pressure switch to cylinder block.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 2: Identifying Oil Pressure Switch
Courtesy of SUBARU OF AMERICA, INC.
Connect the terminal to the oil pressure switch.

Fig 3: Identifying Oil Pressure Switch
Courtesy of SUBARU OF AMERICA, INC.
Install the generator to the bracket. < refer to INSTALLATION , Generator.>
Connect the battery ground terminal.

Fig 4: Connecting Battery Ground Terminal
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.