LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Anti-Lock Brake System - Vehicle Dynamics Control (VDC) (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC C0045 TCM Malfunction >> Trouble Symptom

DTC C0045 TCM Malfunction: Trouble Symptom

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK AT SYSTEM. 
  1. Start the engine.
  2. Check the DTC in AT system.
 Is DTC of AT system displayed? Repair the AT system. < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > Go to step 2  .
2 CHECK VDCCM&H/U. 
  1. Connect all connectors.
  2. Clear the memory. < Ref. to CLEAR MEMORY MODE . >
  3. Perform the Inspection Mode. < Ref. to INSPECTION MODE . >
  4. Read the DTC.
 Is the same DTC displayed? Replace the VDCCM only. < Ref. to REPLACEMENT , VDC Control Module and Hydraulic Control Unit (VDCCM&amp;H/U). > Go to step 3  .
3 CHECK OTHER DTC DETECTION.  Is any other DTC displayed? Perform the diagnosis according to DTC. < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > It results from a temporary noise interference.
scientia non olet · About LEMON Manuals