LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Manual Transmission And Differential) >> Switches and Harness >> Installation >> Back-Up Light Switch & Neutral Position Switch

Back-Up Light Switch & Neutral Position Switch

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the back-up light switch & neutral position switch with the harness.

    Tightening torque: 

    32.3 N.m (3.3 kgf-m, 23.8 ft-lb) 

    Fig 1: Neutral Position Switch And Back-Up Light Switch
    G07665962Courtesy of SUBARU OF AMERICA, INC.
  2. Lower the vehicle.
  3. Connect the connectors of back-up light switch & neutral position switch.
    Fig 2: Neutral Position Switch Connector And Back-Up Light Switch Connector
    G07665963Courtesy of SUBARU OF AMERICA, INC.
  4. Install the air intake boot. < Ref. to INSTALLATION , Air Intake Boot. >
  5. Connect the battery ground terminal.
scientia non olet · About LEMON Manuals