LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Manual Transmission And Differential) >> Reverse Idler Gear >> Installation

Reverse Idler Gear: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reverse shifter lever, washer, reverse idler gear, washer and reverse idler gear shaft, and secure them with the straight pin.
    NOTE:
    • Use a new straight pin.
    • Be sure to install the reverse idler gear shaft from rear side.
    Fig 1: Straight Pin, Reverse Idler Gear Shaft, Washer, Reverse Idler Gear And Reverse Shifter Lever
    G07666108Courtesy of SUBARU OF AMERICA, INC.
  2. Check and adjust clearance between the reverse idler gear and the timing case wall surface. < Ref. to INSTALLATION , Reverse Idler Gear. > < Ref. to ADJUSTMENT , Reverse Idler Gear. >
  3. Install the shifter forks and rods. < Ref. to INSTALLATION , Shifter Fork and Rod. >
  4. Install the front differential assembly. < Ref. to INSTALLATION , Front Differential Assembly. >
  5. Install the main shaft assembly for single-range. < Ref. to INSTALLATION , Main Shaft Assembly for Single-Range. >
  6. Install the drive pinion shaft assembly. < Ref. to INSTALLATION , Drive Pinion Shaft Assembly. >
  7. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  8. Install the transfer case together with the extension case assembly. < Ref. to INSTALLATION , Transfer Case and Extension Case Assembly. >
  9. Install the back-up light switch and the neutral position switch. < Ref. to INSTALLATION , Switches and Harness. >
  10. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals