Reverse Check Sleeve: Disassembly

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Cover the reverse check sleeve with cloth, and remove the snap ring by using screwdriver.
NOTE: If the snap ring is deformed or the spring repulsive force is not enough, replace with a new snap ring.

Fig 1: Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check plate, reverse check spring, reverse check cam, return spring (5th-Re-verse), reverse accent shaft, return spring cap, and return spring (1st-2nd).

Fig 2: Reverse Check Plate, Reverse Check Spring, Reverse Check Cam, Reverse Accent Shaft And Return Spring Cap
Courtesy of SUBARU OF AMERICA, INC.
Remove the O-ring.
NOTE:
- Do not reuse the O-ring.
- Be careful not to damage the adjusting select shim between reverse check sleeve assembly and case.