Reverse Check Sleeve: Assembly

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Rev) and reverse check spring to the reverse check sleeve.
NOTE: Be sure to position the bent section of reverse check spring to fit in the groove of the check cam.

Fig 1: Reverse Check Plate, Reverse Check Spring, Reverse Check Cam, Reverse Accent Shaft And Return Spring Cap
Courtesy of SUBARU OF AMERICA, INC.
Hook the curved section of the reverse check spring over the reverse check plate.
Rotate the cam so that the protrusion of the reverse check cam comes to the opening of the plate.
With cam held in that position, install the reverse check plate onto the reverse check sleeve and hold in place with the snap ring.
Insert the O-ring into the sleeve groove.
NOTE: Use new O-rings.