Malfunction Indicator Light Does Not Go Off: Trouble Symptom
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor display.
DIAGNOSIS PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. | Is DTC of engine or LAN system displayed? Refer to Read Diagnostic Trouble Code (DTC) | Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Refer to List of Diagnostic Trouble Code (DTC) or LIST OF DIAGNOSTIC TROUBLE CODE (DTC) | Go to step 2 . |
| 2 CHECK COMBINATION METER. Perform the self-diagnosis for combination meter system. Refer to COMBINATION METER SYSTEM | Does the malfunction indicator light illuminate and go off normally? | Replace the ECM. Refer to ENGINE CONTROL MODULE (ECM) | Replace the meter case assembly of combination meter. Refer to COMBINATION METER |