LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Engine Controls (Diagnostics) (H4DOTC)) >> Drive Cycle >> Procedure >> Drive Cycle E >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure that the battery voltage is 10.9 V or more.
  2. Perform the Clear Memory Mode. < Refer to CLEAR MEMORY MODE . >
  3. Drive the vehicle for the distance equal to the fuel of 30 l  (7.9 US gal, 6.6 Imp gal).
    NOTE:
    • It is acceptable to drive the vehicle intermittently.
    • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)
scientia non olet · About LEMON Manuals