LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Cruise Control System (Diagnostics)) >> Diagnostics with Phenomenon >> Check Cruise Indicator Light And Cruise Set Indicator Light >> Trouble Symptom

Check Cruise Indicator Light And Cruise Set Indicator Light: Trouble Symptom

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Cruise control can be set, but the cruise indicator light and cruise set indicator light do not illuminate.

DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT. 
  1. Perform the self-diagnosis of combination meter. < Ref. to SELF-DIAGNOSIS , INSPECTION, Combination Meter System. >
  2. Check the cruise indicator light and cruise set indicator light if they illuminate.
 Do the cruise indicator light and cruise set indicator light illuminate? Go to step 2  . Replace the meter case assembly. < Ref. to COMBINATION METER . >
2 CHECK DTC OF LAN COMMUNICATION CIRCUIT. 
  1. Complete self-diagnosis, and turn the ignition switch to ON again.
  2. Read the DTC of body integrated unit using Subaru Select Monitor.
 Is DTC of low-speed CAN displayed? Check the LAN communication circuit. < Ref. to BASIC DIAGNOSTIC PROCEDURE . > Replace the ECM. < Ref. to ENGINE CONTROL MODULE (ECM) . >
scientia non olet · About LEMON Manuals