Front Door

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground cable from battery.
Remove the gusset cover.
1. Pull the gusset cover backward to detach the claws (A) on the backside of the gusset cover.
  
  Fig 1: Detaching Claws On Backside Of Gusset Cover
  Courtesy of SUBARU OF AMERICA, INC.
2. Insert a plastic remover into the position shown in the illustration while retaining the condition in step ( 1), and lift up the gusset cover.
  
  Fig 2: Lifting Up Gusset Cover
  Courtesy of SUBARU OF AMERICA, INC.
3. Remove the gusset cover in the direction of the arrow to detach the clip section (B), and disconnect the connector.
  
  Fig 3: Removing Gusset Cover In Direction Of Arrow And Clip Section
  Courtesy of SUBARU OF AMERICA, INC.
Open the cover of the inner remote section, and remove the screws.

Fig 4: Locating Inner Remote Section Screw
Courtesy of SUBARU OF AMERICA, INC.
Remove the power window switch panel.

Fig 5: Locating Power Window Switch Panel Screw
Courtesy of SUBARU OF AMERICA, INC.
1. Open the cover and remove the screws.
2. Lift up the tip of switch panel by using a plastic remover.
  
  Fig 6: Switch Panel Tip
  Courtesy of SUBARU OF AMERICA, INC.
3. Disengage the end face tabs by using a plastic remover.
  
  Fig 7: Disengaging End Face Tabs By Using A Plastic Remover
  Courtesy of SUBARU OF AMERICA, INC.
4. Disconnect the harness connector, and remove the power window switch panel.
Remove the door trim screws.

Fig 8: Locating Door Trim Screws
Courtesy of SUBARU OF AMERICA, INC.
Remove the door trim.

Fig 9: Door Trim Clips
Courtesy of SUBARU OF AMERICA, INC.
1. Remove the clips, then lift the door trim.
  NOTE: Insert a plastic clip remover into the slit at the bottom of the door trim, to lift the door trim.
  
  Fig 10: Inserting Plastic Clip Remover Into Slit At Bottom Of Door Trim
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the cable (1) and (2) from the cable holder of inner remote.
  
  Fig 11: Inner Remote Cable
  Courtesy of SUBARU OF AMERICA, INC.
3. Disconnect the harness connector and remove the door trim.