Front Wiper Motor and Link: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Connect the battery ground terminal.
To confirm that the motor is at the auto stop position, connect the harness to the motor and turn the wiper switch to ON/OFF once.
Disconnect the ground cable from battery.
Install the wiper motor assembly.

Fig 1: Locating Wiper Motor Assembly Bolts
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Refer to "COMPONENT" of "General Description". < Ref. to FRONT WIPER , COMPONENT, General Description. >
Tighten the nut of the link plate and motor assembly.

Fig 2: Locating Link Plate And Motor Assembly Nut
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.

Fig 3: Rod And Link Plate
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Tighten to 8.5 N.m (0.87 kgf-m, 6.3 ft-lb) by 115°.
Install each part in the reverse order of removal.
Tightening torque:

Refer to "COMPONENT" of "General Description". < Ref. to FRONT WIPER , COMPONENT, General Description. >