LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (HVAC System (Heater, Ventilator And A/C)) >> Blower Motor Unit Assembly >> Removal

Blower Motor Unit Assembly: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the instrument panel lower. < Ref. to INSTRUMENT PANEL LOWER , REMOVAL, Center Console. >
  3. Turn over the floor mat near the engine ECM protect cover.
  4. Remove the bolts and nut, and then remove the engine ECM protect cover.
    Fig 1: Locating Engine ECM Protect Cover Bolts And Nut
    G07666454Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the blower motor relay and blower motor connector.
  6. Remove the relay holder.
  7. Remove the bolts and nuts to remove blower motor unit assembly.
    Fig 2: Locating Blower Motor Unit Assembly Bolts And Nuts
    G07666455Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals