Rear Sub Frame: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground cable from battery.
Lift up the vehicle, and then remove the rear wheels.
Disconnect the connector, and then remove the rear vehicle height sensor, (model with auto headlight beam leveler, left side only)

Fig 1: Locating Rear Vehicle Height Sensor Nuts
Courtesy of SUBARU OF AMERICA, INC.
Separate the front exhaust pipe and rear exhaust pipe.
Remove the rear exhaust pipe and muffler.
Remove the propeller shaft. < Ref. to REMOVAL , Propeller Shaft. >
Remove the brake hose bracket.

Fig 2: Locating Brake Hose Bracket Nut
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear disc brake caliper, and suspend it from the shock absorber.

Fig 3: Rear Disc Brake Caliper
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear parking brake cable from the parking brake assembly. < Ref. to REMOVAL , Parking Brake Assembly (Rear Disc Brake). >
Disconnect the ABS wheel speed sensor connector.

Fig 4: ABS Wheel Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Remove the shock absorber lower bolt.

Fig 5: Locating Shock Absorber Lower Bolt
Courtesy of SUBARU OF AMERICA, INC.
Support the sub frame using a jack.
Remove the support plate.

Fig 6: Locating Sub Frame Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear sub frame.

Fig 7: Locating Rear Sub Frame
Courtesy of SUBARU OF AMERICA, INC.