Rear Bushing

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear bushing with its longer inner cylinder facing upward and the shorter facing downward and protruding part rearward as shown in the illustration.

Fig 1: Rear Bushing Installation Position
Courtesy of SUBARU OF AMERICA, INC.
Align the center of rear bushing recess portion with the aligning mark on the front arm.

Fig 2: Aligning Mark On Front Arm
Courtesy of SUBARU OF AMERICA, INC.
Using the ST and a press, install the rear bushing.
ST1 20299AG000 REMOVER

ST2 20299AG010BASE

Fig 3: Pressing Rear Bushing
Courtesy of SUBARU OF AMERICA, INC.