LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Automatic Transmission) >> Torque Converter Clutch Assembly >> Removal

Torque Converter Clutch Assembly: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from the vehicle. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Pull out the torque converter clutch assembly and oil pump shaft horizontally.
    NOTE: Be sure not to scratch the inside of bushing in oil pump shaft.
    Fig 1: Torque Converter Clutch Assembly
    G07665573Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the input shaft.
    NOTE: When the torque converter clutch assembly is removed, the input shaft will also come off.
    Fig 2: Input Shaft
    G07665574Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the oil pump shaft from torque converter clutch assembly as necessary.
scientia non olet · About LEMON Manuals