Planetary Gear And Low Clutch

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Remove the snap ring from low clutch drum.

Fig 1: Snap Ring And Low Clutch Drum
Courtesy of SUBARU OF AMERICA, INC.
Take out the front planetary carrier.

Fig 2: Front Planetary Carrier And Low Clutch Drum
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear sun gear.

Fig 3: Rear Sun Gear And Rear Planetary Carrier
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear planetary carrier, washer and thrust needle bearing.

Fig 4: Pulling Out Rear Planetary Carrier, Washer And Thrust Needle Bearing
Courtesy of SUBARU OF AMERICA, INC.
Take out the rear internal gear.

Fig 5: Pulling Out Rear Internal Gear
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap ring from low clutch drum.

Fig 6: Snap Ring And Low Clutch Drum
Courtesy of SUBARU OF AMERICA, INC.
Compress the spring retainer of the low & reverse brake, and remove the snap ring from the low clutch drum using ST1 and ST2.
ST1 498627100 SEAT

ST2 398673600 COMPRESSOR

Fig 7: Removing Snap Ring From Low Clutch Drum Using ST1 And ST2
Courtesy of SUBARU OF AMERICA, INC.
Remove the one-way clutch. < Ref. to REMOVAL , AT Main Case. >
Install the one-way clutch inner race to the low clutch drum, and then apply compressed air to remove the low clutch piston.

Fig 8: One-Way Clutch Inner Race
Courtesy of SUBARU OF AMERICA, INC.
Remove the one-way clutch inner race.
Remove the one-way clutch after taking out the snap ring.

Fig 9: Snap Ring, Plate And One-Way Clutch
Courtesy of SUBARU OF AMERICA, INC.
Remove the needle bearing after taking out the snap ring.

Fig 10: Needle Bearing And Snap Ring
Courtesy of SUBARU OF AMERICA, INC.