LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Automatic Transmission - Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P1817 Sports Mode Switch Circuit (Manual Switch) >> Wiring Diagram

DTC P1817 Sports Mode Switch Circuit (Manual Switch): Wiring Diagram

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sports Mode Switch (Manual Switch) Wiring Diagram
G07665857Courtesy of SUBARU OF AMERICA, INC.
DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK SPORT MODE SWITCH GROUND CIRCUIT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from the SPORT shift switch.
  3. Measure the resistance of harness between SPORT shift switch connector and chassis ground.

    Connector & terminal 

    (B117) No. 8 - Chassis ground: 

Is the resistance less than 1 Ω? Go to step 2.  Repair the open circuit of harness between the SPORT shift switch and chassis ground.
2 CHECK SPORT SHIFT SWITCH. 
Measure the resistance between SPORT shift switch terminals.
Connector & terminal 
(B117) No. 7 - No. 8: 
Is the resistance 1 MΩ or more? Go to step 3.  Replace the select lever assembly. < Ref. to SELECT LEVER . >
3 CHECK SPORT SHIFT SWITCH. 
  1. Shift the select lever to SPORT mode.
  2. Measure the resistance between SPORT shift switch terminals.

    Connector & terminal 

    (B117) No. 7 - No. 8: 

Is the resistance less than 1 Ω? Go to step 4.  Replace the select lever assembly. < Ref. to SELECT LEVER . >
4 CHECK HARNESS CONNECTOR BETWEEN TCM AND SPORT SHIFT SWITCH. 
  1. Disconnect the connector from TCM.
  2. Measure the resistance of harness between TCM connector and SPORT shift switch connector.

    Connector & terminal 

    (B117) No. 7 - (B54)No. 17: 

Is the resistance less than 1 Ω? Go to step 5.  Repair the open circuit of harness between TCM and SPORT shift switch connector.
5 CHECK HARNESS CONNECTOR BETWEEN TCM AND SPORT SHIFT SWITCH. 
  1. Disconnect the connector from TCM.
  2. Measure the resistance of harness between TCM connector and chassis ground.

    Connector & terminal 

    (B117) No. 7 - Chassis ground: 

Is the resistance 1 MΩ or more? Go to step 6.  Repair the short circuit of the harness between TCM and SPORT shift switch connector.
6 CHECK INPUT SIGNAL FOR TCM. 
  1. Connect the connector to TCM and SPORT shift switch.
  2. Turn the ignition switch to ON.
  3. Shift the select lever to normal mode.
  4. Measure the voltage of signal to TCM.

    Connector & terminal 

    (B54) No. 17(+) - Chassis ground (-): 

Is the voltage 10 V or more? Go to step 7.  Replace the TCM. < Ref. to TRANSMISSION CONTROL MODULE (TCM) . >
7 CHECK FOR POOR CONTACT.  Is there poor contact in the SPORT shift switch circuit? Repair the poor contact. Replace the TCM. < Ref. to TRANSMISSION CONTROL MODULE (TCM) . >