LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Clutch System) >> Release Bearing and Lever >> Removal

Release Bearing and Lever: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from the vehicle. < Ref. to REMOVAL , Manual Transmission Assembly . >
  2. Remove the two clips from the release lever and remove the release bearing.
    CAUTION: Be careful not to deform the clips.
  3. Remove the dust cover.
    Fig 1: Release Lever And Dust Cover
    G07680098Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the lever spring from the pivot with a screwdriver by accessing it through the clutch housing release lever hole. Then remove the release lever.
    Fig 2: Removing Lever Spring From Pivot With Screwdriver
    G07680099Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals