LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Fuel Injection System - Fuel Injection (H4DOTC)) >> Fuel >> Procedure >> Releasing Of Fuel Pressure

Releasing Of Fuel Pressure

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION: Be careful not to spill fuel.
  1. Remove the fuse of fuel pump from main fuse box.
    Fig 1: Locating Fuse Of Fuel Pump From Main Fuse Box
    G07670526Courtesy of SUBARU OF AMERICA, INC.
  2. Start the engine and run it until it stalls.
  3. After the engine stalls, crank it for five more seconds.
  4. Turn the ignition switch to OFF.
  5. Install the fuse of fuel pump to the main fuse box.