LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Engine Intake System (Induction) And Turbocharger (H4DOTC)) >> Air Cleaner Case >> Removal

Air Cleaner Case: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G07680891Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the air intake duct (rear). < Ref. to REMOVAL , Air Intake Duct. >
  4. Disconnect the connector (A) from air flow and intake air temperature sensor.
  5. Loosen the clamp (B) which holds the air intake boot.
  6. Remove the clip (C) from the air cleaner case (front).
    Fig 2: Air Flow And Intake Air Temperature Sensor Connector, Air Intake Boot Clamp And Air Cleaner Case (Front) Clip
    G07680892Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air cleaner case (rear) and air intake boot.
  8. Remove the air cleaner element.
  9. Remove the bolts (A) and nuts (B) which secure the air cleaner case (front) to the body.
    Fig 3: Bolts And Nuts Which Secure Air Cleaner Case (Front) To Body
    G07680893Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the air cleaner case (front).
scientia non olet · About LEMON Manuals