Rear Sealing Cover: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install each part in the reverse order of removal.
When replacing the sealing cover, use the butyl tape.
Press the butyl tape-applied area firmly to prevent any floating on surface.
Butyl tape: 3M8626 or the equivalent
NOTE:
- Apply a uniform bead of butyl tape.
- Attach the sealing cover, keeping it from becoming wrinkled.
- If the butyl tape is applied unevenly, it will cause water leakage and soiling.