LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Body Panel System - Exterior Body Panels) >> Rear Gate >> Removal >> Rear Gate Panel

Rear Gate Panel

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from the battery.
  2. Remove the rear gate trim. < Ref. to REMOVAL , Rear Gate Trim. >
  3. Remove the rear gate garnish. < Ref. to REMOVAL , Rear Gate Garnish. >
  4. Remove the rear wiper arm. < Ref. to REMOVAL , Rear Wiper Arm. >
  5. Remove the rear wiper motor. < Ref. to REMOVAL , Rear Wiper Motor. >
  6. Remove the rear gate latch and actuator assembly. < Ref. to REMOVAL , Rear Gate Latch and Actuator Assembly. >
  7. Remove the roof spoiler. < Ref. to REMOVAL , Roof Spoiler. >
  8. Remove the connecting part of rubber duct (A).
    Fig 1: Rubber Duct
    G05958216Courtesy of SUBARU OF AMERICA, INC.
  9. Pull off the harness and washer hose from the rear gate.
  10. Remove harness clip of each connector from the rear gate panel.
  11. Before removing the rear gate damper stay, prevent the rear gate from closing using prop or the like.
    CAUTION: If the prop comes off, operators may get injured and vehicle may get damaged. Make sure to support the rear gate with secure material to prevent injury or damage.
    Fig 2: Supporting Rear Gate Using Prop
    G05958217Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the mounting bolt of rear gate damper stay.
    Fig 3: Removing Mounting Bolt Of Rear Gate Damper Stay
    G05033828Courtesy of SUBARU OF AMERICA, INC.
  13. Remove the rear gate hinge bolt, and remove the rear gate panel.
    Fig 4: Locating Rear Gate Hinge Bolt
    G05004598Courtesy of SUBARU OF AMERICA, INC.
  14. Remove the rear gate hinge from the vehicle.