LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Body Panel System - Exterior Body Panels) >> Front Door >> Installation

Front Door: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Put a wooden block on jack and place the front door on that.
    Fig 1: Positioning Jack Under Front Door
    G05004578Courtesy of SUBARU OF AMERICA, INC.
  2. Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.
  3. Install the front door to upper hinge and lower hinge adjusting by jack.
  4. Tighten bolt of door checker.
  5. Connect door harness connector, and install the instrument panel lower cover.
  6. Install the front pillar lower trim.

    Tightening torque:  Refer to "COMPONENT" of "General Description". < Ref. to REAR DOOR , COMPONENT, General Description. >

  7. Install while paying attention to make a uniform clearance around the front door panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description". < Ref. to SPECIFICATION , General Description. >
scientia non olet · About LEMON Manuals