Hydraulic Pump Motor, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Motor -1- By Lightly Turning It Off Of Valve Block -2-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening specification. Refer to OVERVIEW - HYDRAULIC SYSTEM .

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

-- Install the new O-ring onto the valve block.

-- Attach the motor to the valve block.

Align the shaft -1- in accordance with the opening in the yoke -2- as shown in the illustration.

-- Install the motor by lightly turning it onto the valve block.

-- Install the hydraulic pump. Refer to HYDRAULIC UNIT (HYDRAULIC PUMP), REMOVING AND INSTALLING .

-- Check the fluid level and fill with fluid if necessary. Refer to HYDRAULIC SYSTEM, FILLING AND BLEEDING .