Convertible Top Headliner, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Protective Strip For Convertible Top Headliner From Groove For "Rail 1 And 2"

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal. Note the following:

NOTE:

Replace self-locking screws.

Always place the cap -2- on the retaining rod -1- to avoid damaging the convertible top headliner.

-- Clean off any locking fluid residue with a thread cutter in the threaded holes in which the self-locking screws are installed.

-- Install the convertible top headliner and guide the protective strip into the groove for "rail 1 and 2" at the same time.

-- Reattach the tension- and guide cable on the right side for the convertible top headliner identical to those on the left side. Refer to OVERVIEW - CONVERTIBLE TOP .

-- Remove the old convertible top headliner and reattach the tension- and guide cables identical to the right side. Refer to OVERVIEW - CONVERTIBLE TOP .

-- Install the rear interior lamp. Refer to CONTROLS .

-- Install the front trim. Refer to FRONT TRIM PANEL, REMOVING AND INSTALLING .