Steering Column Electronics Control Module -J527-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.

-- Adjust steering wheel downward and to rear as far as possible, use entire adjustment range of steering column adjustment for this.

-- Remove the driver airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING / OVERVIEW - DRIVER SIDE AIRBAG / OVERVIEW - STEERING WHEEL .

-- Remove the steering wheel. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING / OVERVIEW - DRIVER SIDE AIRBAG / OVERVIEW - STEERING WHEEL .

-- Remove the steering column trim panel. Refer to OVERVIEW - STEERING COLUMN TRIM PANEL / UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING / LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the bolt -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the retaining hooks -arrows- carefully and remove the Airbag Spiral Spring/Return Spring with Slip Ring -F138- -2- from the steering column switch module -3-.

-- Release the electrical connectors on the Airbag Spiral Spring/Return Spring with Slip Ring -F138- -3- by positioning the screwdriver at the retaining hooks -2- and -4- as illustrated below and carefully releasing the connectors -1- and -5- in the direction of -arrow A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Airbag Spiral Spring/Return Spring with Slip Ring -F138- on the steering column switch module.