Memory Stop, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Slider And Seat Rail

Courtesy of AUDI OF AMERICA, LLC

-- If the memory stop has been replaced, clean the seat rail area to remove any residue from the previous memory stop.

-- Insert the memory stop into the seat rail -1- by gently tipping it toward the tunnel.

-- Lock the memory stop in the very last hole -arrow-.

-- Tighten the rear seat bolt on the tunnel side. Refer to -item ) OVERVIEW - FRONT SEAT, MANUAL STANDARD SEAT - BOLTS.

-- Tilt the backrest back while sliding the seat toward the rear at the same time (entry assistance system).

-- Release the seat forward/back adjuster and slide the front seat into the desired position.

NOTE:

It is not necessary to adjust the memory stop separately.